Can you confirm the resistance between all of these? 80 Ohm? or Nothing. Thanks
So between all of these points I got around the same value most of the time. That's for both GND and 3.3v to G3/G4/G5.Ok great, and between GND to G3/G4/G5 and 3.3V to G3/G4/G5.
I just want to confirm there is nothing shorted on the PS1D, so we can focus attention to exactly where the problem.
I've tried to pull out solder but I just can't see where the bridge is. Is it possibly underneath the flex?G4 is shorted to 3.3V on the flex. Lets just focus on that.
Focus on those two pins only. Put flux down with and use a clean tip with no solder. Try and pull solder out. Reverify the bridge is gone with a meter.
View attachment 37
Dan you are the man!! I'm finally getting crispy pixels! All hearts! I ended up desoldering the entire flex with hot air and resoldering it back down. With very careful drag soldering I got it back down! Thank you for your time and effort. I learned a ton and feel like I'm a better modder now.Yeah its possible. You can also try to pull the solder up with braid. and remove all solder from the area. Confirm the bridge is gone then resolder.