Hello, I finally found some time to install my PS1Digital, but I'm encountering some troubles.
At first analog video and audio was still working fine, after I installed the PS1Digital.
Over HDMI the startup screen and menu was visible, but flickering, and there was no audio. And after about half a minute, the screen turned to black with some flickering specks. The PS1Digital LED was flickering slightly. ( video of flickering screen, video of flickering LED )
I couldn't find any bridges with my Multimeter. 3.3V and 5V voltage seemed to be OK.
After that I resoldered all connections of the GPU and audio flex cables.
But now, analog video either only shows a black screen or also a flickering startup screen that changes to black after a few seconds. If there is only a black screen, the startup sound plays for 1-2 seconds and then holds the same tone. If the flickering image apears, then audio holds the tone, after the screen turns to black.
The behavior with HDMI at first was the same as before: visible picture with flickering, then turning to black, no audio, flickering LED.
After I switched from analog back to HDMI, the TV now apparently doesn't receive a HDMI signal from the PS1Digital anymore. The LED is still flickering as before.
Again, I can't find any bridges with the Multimeter and the voltage is OK.
When HDMI was still showing the flickering image, I couldn't really tell, if the self test was working. I saw just some small specks on a black screen, similar to the image, that appeared, after the image changed from the flickering menu screen to a black screen. But I think the TV was changing the resolution.
What could be the reason for this behavior? Are there some specific pins, that are most likely causing the problems?
At first analog video and audio was still working fine, after I installed the PS1Digital.
Over HDMI the startup screen and menu was visible, but flickering, and there was no audio. And after about half a minute, the screen turned to black with some flickering specks. The PS1Digital LED was flickering slightly. ( video of flickering screen, video of flickering LED )
I couldn't find any bridges with my Multimeter. 3.3V and 5V voltage seemed to be OK.
After that I resoldered all connections of the GPU and audio flex cables.
But now, analog video either only shows a black screen or also a flickering startup screen that changes to black after a few seconds. If there is only a black screen, the startup sound plays for 1-2 seconds and then holds the same tone. If the flickering image apears, then audio holds the tone, after the screen turns to black.
The behavior with HDMI at first was the same as before: visible picture with flickering, then turning to black, no audio, flickering LED.
After I switched from analog back to HDMI, the TV now apparently doesn't receive a HDMI signal from the PS1Digital anymore. The LED is still flickering as before.
Again, I can't find any bridges with the Multimeter and the voltage is OK.
When HDMI was still showing the flickering image, I couldn't really tell, if the self test was working. I saw just some small specks on a black screen, similar to the image, that appeared, after the image changed from the flickering menu screen to a black screen. But I think the TV was changing the resolution.
What could be the reason for this behavior? Are there some specific pins, that are most likely causing the problems?