Pickle Jar
New member
Everything went smoothly until reseating the board back into the case, adjusting some cable pinching, saw the IC206 test pad cable had come off with the pad still attached to the wire.
The video says this is part of the reset circuit. Is it necessary for operation? Is there another connection point to tap into? Looks like this pad may go to the other side of the board into the chip? Does anyone have the schematics to this area of the board?
Many thx.
The video says this is part of the reset circuit. Is it necessary for operation? Is there another connection point to tap into? Looks like this pad may go to the other side of the board into the chip? Does anyone have the schematics to this area of the board?
Many thx.