Can't get to the OSD menu

flclkrazy

New member
I installed my DCHDMI and have working video and audio through hdmi. The controller works with games. The problem is I can't get to the menu. Left Trigger + Right Trigger + X + A + Start does nothing. I have P1 to R601, P2 to R602, RST to test point, and OPT to nowhere. I checked the continuity and it's good.
 

citrus3000psi

Administrator
Staff member
Got any pictures of the install? Also you might need to wait 30 seconds before the OSD will pull up, if its unable to connect to the wifi AP (assuming its setup)
 

flclkrazy

New member
Sorry about taking so long to respond. I spent my winter break visiting parents. The AP isn't setup yet because I can't get to the OSD menu. I tried waiting a couple minutes but it still won't work. I originally soldered the wires and the menu wouldn't work for me. I had my mom go over and resolder the wires at work for me and she damaged the test point pad. So that's why the why the wire the reset wire is attached to the resistor instead of the the test point.
IMG_20210119_143603.jpgIMG_20210119_143528.jpg


IMG_20210119_143401 (2).jpg
 

flclkrazy

New member
Alright, what can I do next to troubleshoot this? I've come back to it two months later and I'm still at the same spot. No OSD. No hearts. Nothing. Video and audio works. I can see the wifi access point but have never connected it to a network since I've never gotten to the OSD. I do have a scope laying around but minimal experience.
 
Top