I was hoping someone could help me. I've managed to install the DCDigital I purchased from 8bitmods in the UK and the video outputs perfectly and I can get in to the OSD without any issues.
However, the audio crackles whenever there is supposed to be sound. This DOES NOT happen when using the old RF cable.
It's worth mentioning that when I was soldering the flex cable to the audio IC, the surface pad came off (3rd pin over from the left and I've highlighted this in the attached photo). I suspect this may be the culprit but I'm not sure why if works OK over the RF cable as it doesn't seem like the flex cable has a link to that pin. I am unable to create a jumper on the PCB to this particular pin as I'm unsure where the trace goes.
I have used a multimeter/continuity tester on all solder points on the flex cable and I don't have any bridges so I'm at a loss.
Also, I noticed the video tutorial mentioned that JP1 needs to be jumped but I couldn't find this on the flex cable.
If anyone has any suggestions, it would be greatly appreciated. Many Thanks
However, the audio crackles whenever there is supposed to be sound. This DOES NOT happen when using the old RF cable.
It's worth mentioning that when I was soldering the flex cable to the audio IC, the surface pad came off (3rd pin over from the left and I've highlighted this in the attached photo). I suspect this may be the culprit but I'm not sure why if works OK over the RF cable as it doesn't seem like the flex cable has a link to that pin. I am unable to create a jumper on the PCB to this particular pin as I'm unsure where the trace goes.
I have used a multimeter/continuity tester on all solder points on the flex cable and I don't have any bridges so I'm at a loss.
Also, I noticed the video tutorial mentioned that JP1 needs to be jumped but I couldn't find this on the flex cable.
If anyone has any suggestions, it would be greatly appreciated. Many Thanks
Last edited: