Search results

Just to close this thread, I went over the soldering with my iron and the issue seems to have been down to a poor connection on the flat flex cable. Drowning the board in even more flux and holding the iron on each pin for about 2 seconds seems to have resolved the problem ;-) As a cautionary...

Hi Chris, Thanks very much for your reply. 1.) I will add further solder as requested to the Video DAC pins and get back to you. 2.) It is hard to witness if the LED on the DCDigital has lit up, I certainly can't see anything albeit with the console partially assembled, however the DCDigital...

Looks like we are all in different timezones :-) For completeness's sake, I had a few questions. 1.) Is it possible to apply 3.3V and GND from my bench power supply to power up the DCDigital board and then connect this to my TV? I just want to see if a test image can be generated to rule out...

Dreamcast Revision: VA1 - PAL Dreamcast Motherboard Revision: "IC BD KATANA MAIN VA1 MADE IN JAPAN 837-13778, SEGA 1999 171-7965E SEGA" DC Digital Revision: 1.3a Vendor: A distributor in the United Kingdom Hi, I have just purchased 3 DC Digital units from a distributor in the United Kingdom...