Removed all solder, resoldered all points, checked for continuity and shorts. Now I get video, but still no audio even after changing the Enhanced DVI mode on/off.
Definitely try reflowing all points. I had a similar issue on a new install, and used my desolder gun to remove all solder, and started over again. With all the points resoldered, I get video; still trying to determine the no audio issue though.
The board is receiving 3.3v. Triple checked continuity on all points, no bridges, shorts, etc. LED only flashes for half a second then turns off. No video or sound.
Attempted to upload photo from mobile; no luck. Will try on PC at a later time.
GCLoader won't work with an SD extension
cable. I've tried 2 different GCLoader's and 3 different extension cables, all on the same console. It works when the card is plugged directly into the GCLoader socket. I've tested all the extension cables on my PC with no problem.
I get a system error...
Had the same issue with video cutting out several seconds after boot. After reading this post, I decided to check my fan and noticed it was not spinning. The connection must have come loose after reassembly.
This post seems to have solved my issue. Thanks.