Search results

  1. E

    Continuity, video DAC pins, D0 and VCLK

    Check your flex cable pins and this resistor, sometimes solder can fall of your tip while doing the install.
  2. E

    No Boot (No composite/No HDMI/No Audio)

    Test your ribbon cable for continuity from the solder pins to the end of the flex cable make sure al pins pass and it has no shorts exept for ground. As for the r601 r602 it might be that the dchdmi has to connect before going up to the controller port. Soldering after r601 to fl601 might be...
  3. E

    No Boot (No composite/No HDMI/No Audio)

    Check those two spots for damage from the gdrom screws. Sometimes installing the wrong screw on the gdrom damages the via trace