Quick solder RGB pcb

juanmiglesias

New member
Hi there, I bought a couple of quick solder scart pcbs, was wondering if there is a bom file or a list of parts for each configuration, I got the capacitors already on the right height, looking for the resistors package size.
and also I have a quick question, are these compatible with Genesis 2? I see it requires a resistor and a capacitor on each line, but looking at the board, it seems it can be configured with either capacitor only or resistors only. any insight?
thanks.
 

citrus3000psi

Administrator
Staff member
This board is not designed to be used in any scenario. So if you want to use resistors and caps, you will need to get creative. Such as use throughhole resistors or cut traces on the PCB and insert the resistors inline.

There is no parts list. The resistor package size is 0603.
 

juanmiglesias

New member
This board is not designed to be used in any scenario. So if you want to use resistors and caps, you will need to get creative. Such as use throughhole resistors or cut traces on the PCB and insert the resistors inline.

There is no parts list. The resistor package size is 0603.
Awesome thanks for the quick reply, 0603 will be then to keep it in style, although I see I will likely not used the pads for them after routing the traces and comparing schematics (ntsc consoles).
So these boards are more of an easy Universal DIY RGB scart pcb, nice, wish I had these before I did my first set of cables using a vga connector years back. hehe
For Genesis 2, I'm just adding the resistor right after the input (cable pad) trace, after cutting the trace itself of course, and then just route to each capacitor and leaving jumpers off of course.
the ones with no caps are pretty straight forward, same with the ones needing the caps, but yeah overall I think I have it figured out.
Do you mind if I update the board file to add the resistors pads for a gen2, and create instructions for it?, will share on oshpark of course.
 
Top